TM 5-2420-230-24-1
12. Using an appropriate-sized socket or bushing
driver, remove the seals by pushing them out
using light hammer blows. Discard the old
seals (Figure 72).
13. Clean the bearing cap with an approved
solvent and blow it dry with low pressure air.
WARNING
ALWAYS WEAR SAFETY GLASSES AND
USE LOW PRESSURE AIR ONLY TO
CLEAN PARTS.
Figure 72
14. Turn the cap over and install the input shaft
seal using a seal driver. Insure the lip of the
seal is facing you (toward pressure). Press the
seal in until it bottoms, using an arbor press
(Figures 73 & 74).
Figure 73
NOTE:
A light coat of oil or grease is recommended
on the outside diameter of the seal for easier
installation.
Figure 74
K-68