TM 5-2420-230-24-2
L-22. ENGINE REPAIR (FRONT COVER REPLACEMENT).
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
References
None
None
Tools and Special Tools
Equipment Conditions
Inserter, seal, Item 27, Appendix B
TM or Para
Condition Description
Tool kit, common no. 2, Item 36, Appendix B
Fan pulley removed.
Tool kit, general mechanics, Item 38, Appendix B
Vibration damper/crankshaft
pulley removed.
Para 4-4
Engine oil filter removed.
Materials/Parts
Oil, lubricating, OE/HDO-30, Item 44, Appendix C
Three Bond 1207-C, Item 67, Appendix C
Drawings Required
Gasket, Item 66, Appendix D
TM 5-2420-230-24P Figure 18
Gasket, Item 78, Appendix D
Packing, performed, Item 164, Appendix D
Estimated Time to Complete
Seal, Item 227, Appendix D
Refer to MAC in Appendix B
Personnel Required
MOS 62B, Construction Equipment Repairer
a. Removal.
Refer to page L-111 for removal.
b. Installation.
Adhesives, solvents, and sealing compounds burn easily and give off vapors that are harmful to the
skin and clothing. To avoid injury or death, keep away from open fire when using these materials, and
use only in well-ventilated areas. If adhesives, solvents, or sealing compounds contact the skin or
clothing, wash immediately with soap and water, and rinse thoroughly. Failure to comply may result
in injury or death to personnel.
Refer to page L-180 for installation.
c. Follow-On Maintenance.
(1)
Install fan pulley (Para L-7).
(2)
Install vibration damper/crankshaft pulley (Para L-8).
(3)
Install engine oil filter (Para 4-4).
END OF TASK
Change 1
