TM 5-2420-230-24-2
L-18. INJECTOR NOZZLES REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Personnel Required
None
MOS 62B, Construction Equipment Repairer
References
Tools and Special Tools
None
Puller, flexible injector, Item 30, Appendix B
Equipment Conditions
Tool kit, common no. 2, Item 36, Appendix B
TM or Para
Condition Description
Tool kit, general mechanics, Item 38, Appendix B
High pressure fuel lines
Materials/Parts
removed.
Antiseize compound, Item 12, Appendix C
Drawings Required
Oil, lubricating, 15W40, Item 44, Appendix C
TM 5-2420-230-24P Figure 37
Solvent, penetrating, Item 59, Appendix C
Estimated Time to Complete
Seal, rectangular, Item 228, Appendix D
Refer to MAC in Appendix B
Seal, banjo, Item 238, Appendix D
a. Removal.
No smoking, flames, sparks, or glowing or hot objects allowed within 50 ft. (15 m) of vehicle.
Failure to comply may result in injury or death to personnel.
To prevent possible injury, wear gloves and protective eye equipment when handling fuel. Failure
to comply may result in injury or death to personnel.
Keep a fire extinguisher within easy reach when working with fuel or on a fuel system.
Do not work on fuel system when engine is hot; fuel can be ignited by a hot engine.
Refer to page L-109 for removal.
b. Installation.
Adhesives, solvents, and sealing compounds burn easily and give off vapors that are harmful to the
skin and clothing. To avoid injury or death, keep away from open fire when using these materials, and
use only in well-ventilated areas. If adhesives, solvents, or sealing compounds contact the skin or
clothing, wash immediately with soap and water, and rinse thoroughly. Failure to comply may result
in injury or death to personnel.
Refer to page L-188 for installation.
c. Follow-On Maintenance.
Install high pressure fuel lines (Para L-14).
END OF TASK
Change 1