TM 5-2420-230-24-2
Cylinder Head - Installation (0-99)
Section 0 - Engine Disassembly and Assembly - Group 00
Page 0-92
B Series Shop Manual
Apply a thin bead of Three BondTM to the cover side of the
front cover gasket only.
NOTE: Do not remove the plastic seal pilot tool from the
lubricating oil seal at this time. Use the plastic seal pilot tool
to guide the seal on the crankshaft.
Install the gasket and front cover on the engine.
10 mm
Remove the alignment/installation tool after tightening
the capscrews.
Torque Value: 24 Nm
[18 ft-lb]
Install the front cover access cap and seal.
Cylinder Head - Installation (0-99)
Caution: Make sure the cylinder head and block surface
are clean and not nicked or gouged.
Mallet
If removed, install the two cylinder head dowels. Drive the
dowels to the bottom of the dowel bore.
L-181