TM 5-2420-230-24-2
Crankshaft Gear - Replacement (1-13)
Section 1 - Cylinder Block - Group 1
Page 1-28
B Series Shop Manual
Hammer
If previously removed, install the alignment pin until it
bottoms.
Caution: The gear will be permanently distorted if over-
heated. The oven temperature should never exceed
177C [350F].
Heat the crankshaft gear in a preheated oven for 45 min-
utes at 149 C [300 F].
Apply a thin coating of lubricant to the nose of the
crankshaft.
Warning: Wear protective gloves to prevent personal in-
jury.
Install the hot gear up to the crankshaft shoulder with the
timing mark out.
L-231