TM 5-2420-230-24-2
Timing Pin Housing (001-049)
B3.9 and B5.9 Series Engines
Page 1-90
Section 1 - Cylinder Block - Group 01
Position the rings so the ring gap are 120 degrees apart.
Timing Pin Housing (001-049)
Preparatory (001-049-000)
Engine Barring Tool, Part No. 3824591
Locate top dead center (TDC) for cylinder No. 1 by barring
crankshaft slowly while pressing on the engine timing pin.
Service Tip: If the timing pin has been damaged and can
not be used to locate TDC, refer to Procedure 005-037.
Remove (001-049-002)
T-25 Torx
R
emove the timing pin assembly and seal.
Install (001-049-026)
Install a new seal and, if required, new timing pin assembly.
Hold the pin (A) in the hole (B) in the camshaft gear to align
the housing.
Torque Value: 5 Nm
[48 in-lb]
L-768