TM 5-3805-280-24-2
Camshaft, Balancer Shafts and Timing Gear Train
4. Apply LOCTITE 515 Flexible Form-In-Place Gasket
16
47
(TY6304) in a continuous 1.5--2.0 mm bead (A) to
cylinder block.
5. Locate bead in the center of the mating surfaces and
completely encircle cap screw and dowel holes.
A--Flexible Gasket Pattern
LOCTITE is a registered trademark of the Loctite Corp.
RG,16,DT7476 1914NOV972/3
6. Install front plate (D).
IMPORTANT: Tighten screws to specified torque
using a cross pattern, within 10 minutes
after parts are assembled.
NOTE: On earlier engines1, there are two
countersunkTORX screws in place of threaded
studs (C).
Front Plate Countersunk TORX Screws (A)--Specification
Torque ............................................................................. 25 Nm (18 lb-ft)
A--Countersunk TORXScrews
Front Plate Threaded Studs (B) and (C)--Specification
B--Threaded Studs
C--Threaded Studs
Torque ............................................................................. 35 Nm (26 lb-ft)
D--Front Plate
TORX is a registered trademark of Camcar/Textron
1
Serial Numbers: Dubuque-built engines ( --703904), Saran-built
engines ( --516217), Torreon-built engines (Does not apply).
RG,16,DT7476 1914NOV973/3
13-279
