TM 5-3805-281-24-2
Removal and Installation
5. Replace parts as necessary.
b. Next tighten 3/8 in. cap screws.
Oil Pan-to-Cylinder Block Cap Screw (3/8 in.)--
NOTE: At oil pan and cylinder block (including timing
Specification
gear cover and rear seal housing) gasket
sealing surfaces MUST BE free of gasket
Torque....................................................................... 68 Nm (50 lb-ft)
material or oil and dry.
11. Trim oil pan gasket flush at rear surface of
6. Apply a thin layer of Permatex Aviation
cylinder block and oil pan.
(Form-A-Gasket No. 3, TY6299) at timing gear
cover-to-cylinder block mating surfaces.
12. Retighten all oil pan cap screws as follows:
7. Apply a thin layer of Permatex Aviation
a. First retighten 3/8 in cap screws.
(Form-A-Gasket No. 3, TY6299) at rear oil seal
housing-to-cylinder block mating surfaces.
Oil Pan-to-Cylinder Block Cap Screw (3/8 in.)--
Specification
8. Position new oil pan gasket on cylinder block.
04
Torque....................................................................... 68 Nm (50 lb-ft)
0400
9. Apply a thin layer of Permatex Aviation
18
b. Finally retighten 1/2 in. cap screws.
(Form-A-Gasket No. 3, TY6299) to gasket at the
same location as cylinder block noted above.
Oil Pan-to-Cylinder Block Cap Screw (1/2 in.)--
Specification
NOTE: Locate rear of oil pan flush to 0.05 mm
(0.002 in.) with rear face of cylinder block.
Torque................................................................... 156 Nm (117 lb-ft)
10. Carefully install oil pan on cylinder block and
13. Fill engine oil. (See Fuels and Lubricants in Group
tighten all oil pan-to-cylinder block cap screws as
0004).
follows:
14. Install engine. (See procedure in Group 0400).
a. First tighten 1/2 in. cap screws.
Oil Pan-to-Cylinder Block Cap Screw (1/2 in.)--
Specification
Torque................................................................... 156 Nm (117 lb-ft)
CED,OUOE024,203
1912MAY982/2
DISASSEMBLE AND ASSEMBLE ENGINE
Refer to Engine Repair chapter for disassemble and
assemble procedures.
CED,OUOE024,230
1921MAY981/1
