TM 5-3805-294-10
OPERATOR MAINTENANCE
OPERATING THE DEEP DIG ARM
INITIAL SETUP:
Equipment Condition
References
Engine running. WP 0007
DEEP DIG ARM OPERATION
CAUTION
Do not attempt to extend the arm cylinder with the deep dig arm attached. The deep dig arm
can strike the machine. Failure to comply may result in damage to equipment.
NOTE
After the Deep Dig Attachment has been installed on the machine, the following steps must
be performed to enable Deep Dig Arm Operation.
1.
Remove clip (Figure 1, Item 1) from switch bracket (Figure 1, Item 2).
HYEX01519
3
2
1
Figure 1.
Deep Dig Control Pattern Switch.
2.
Move switch (Figure 1, Item 3) to ON position and install pin (Figure 1, Item 1).
3.
Switch A/I (Figure 2, Item 4) to on position