TM 5-3805-294-23-1
0023
Table 1. DTC 100.18 - Engine Oil Pressure Signal Moderately Low - Continued.
Test or Inspection
Corrective Action
Malfunction
13.
Turn the key switch to the OFF
1.
If voltage was between 0.3 -
position (TM 5-3805-294-10).
0.7 volts, problem was not
found and may have been
(Volume 5, WP 0794)
missed during
troubleshooting. Install engine
oil pressure sensor. (Volume
3, WP 0417) Restart
procedure at Malfunction 1.
2.
If voltage was not between 0.3
- 0.7 volts and engine oil
pressure sensor was
previously replaced, proceed
to Malfunction 7.
3.
If not between 0.3 - 0.7 volts
and engine oil pressure sensor
has not been previously
replaced, replace engine oil
pressure sensor. (Volume 3,
WP 0417) Restore machine to
original condition and operate
engine through normal speed
and load (TM 5-3805-294-10).
(Volume 5, WP 0794) Clear
and refresh DTCs. (Volume 3,
WP 0362)
1.
Disconnect negative battery
7.
Check For DTC
100.04 Active
cable. (Volume 4, WP 0521)
Status With Engine
Wiring Harness
Connector J03
Disconnected.
2.
Install engine oil pressure
sensor. (Volume 3, WP 0417)
3.
Disconnect engine wiring
harness connector J03 from
ECU. (Volume 5, WP 0800,
Figure 48)
4.
Connect negative battery
cable. (Volume 4, WP 0521)
5.
Turn the key switch to the ON
position, but DO NOT START
ENGINE (TM 5-3805-294-10).
(Volume 5, WP 0794)
0023-6