TM 5-3805-294-23-1
0116
Table 1. Engine Does Not Develop Full Power - Continued.
Test or Inspection
Corrective Action
Malfunction
1.
Reconnect connector X27.
15.
0.3 - 1.0 Volts Not
Present Between
(Volume 5, WP 0800, Figure
Connector X27 Pin
93)
2 and Ground While
Engine Speed Dial
is Set to SLOW
IDLE.
2.
Set engine speed dial to
SLOW IDLE. (TM
5-3805-294-10) (Volume 5,
WP 0794)
3.
Turn key switch to ON position,
but DO NOT START ENGINE
(TM 5-3805-294-10). (Volume
5, WP 0794)
4.
Measure voltage (Volume 3,
WP 0369) between back of
connector X27 pin 2 (Volume
5, WP 0800, Figure 93) and a
known good ground. Note
reading.
5.
Turn key switch to OFF
1.
If between 0.3 - 1.0 volts,
position (TM 5-3805-294-10).
proceed to Malfunction 16.
(Volume 5, WP 0794)
If not between 0.3 - 1.0 volts,
2.
replace right-hand console
switch panel. (Volume 4,
WP 0525)Restore machine to
original condition and operate
engine through normal speed
and load. (TM 5-3805-294-10)
(Volume 5, WP 0794)Clear
and refresh DTCs. (Volume 3,
WP 0362)
1.
Remove main controller.
16.
Connector X30 or
X31 Has Damage or
(Volume 4, WP 0517)
Loose Sockets.
0116-8