TM 5-3805-294-23-1
0123
Table 1. Engine Will Not Crank - Continued.
Test or Inspection
Corrective Action
Malfunction
Visually inspect connector V44
1.
If damaged or has loose pin/
19.
Connector V44 Has
for damage and loose pin/
socket, replace starter
Damage or Loose
protection wiring harness.
Pin/Socket.
socket. (Volume 5, WP 0800,
Figure 81)
(Volume 4, WP 0528) Restore
machine to original condition.
2.
If not damaged and does not
have loose pin/socket,
proceed to Malfunction 20.
1.
Verify the key switch is in the
20.
Voltage Between
OFF position (TM
Relay K34 Sockets
5-3805-294-10). (Volume 5,
G01 and E14 Not
Within 2 Volts of
WP 0794)
Battery Terminal
Voltage.
2.
Measure voltage (Volume 3,
WP 0369) between battery
negative and positive
terminals. (Volume 5,
WP 0800, Figure 5) Note
battery terminal voltage.
3.
With the aid of an assistant,
measure voltage (Volume 3,
WP 0369) between relay K34
sockets G01 and E14 (Volume
5, WP 0800, Figure 212) while
turning key switch to START
position for 3 seconds.
(Volume 5, WP 0794) Note
reading.
4.
Turn key switch to OFF
1.
If within 2 volts of battery
position (TM 5-3805-294-10).
terminal voltage, proceed to
Malfunction 21.
(Volume 5, WP 0794)
If not within 2 volts of battery
2.
terminal voltage, replace
ground wire. (Volume 4,
WP 0528) Restore machine to
original condition.
1.
Verify the key switch is in the
21.
Voltage Between
OFF position (TM
Relay K34 Wire
5-3805-294-10). (Volume 5,
Terminal E03 and
Ground Not Within
WP 0794)
2 Volts of Battery
Terminal Voltage.
0123-8