TM 5-3805-294-23-1
0130
Table 1. High-Pressure Fuel Supply System Test - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If less than 10 ohms, proceed
19.
Open Circuit
to Malfunction 20.
Between Engine
3, WP 0369) between engine
Wiring Harness
wiring harness connector J03
2.
If greater than 10 ohms,
Connector J03
socket C1 (Volume 5,
replace engine wiring
Socket C1 and
WP 0800, Figure 48) and
harness. (Volume 4,
Engine Wiring
engine wiring harness
WP 0510) Restore machine to
Harness Connector
connector P05 socket 1
original condition. Clear and
P05 Socket 1.
(Volume 5, WP 0800, Figure
refresh DTCs. (Volume 3,
57). Note reading.
WP 0362)
Measure resistance (Volume
1.
If less than 10 ohms, proceed
20.
Open Circuit
to Malfunction 21.
Between Engine
3, WP 0369) between engine
Wiring Harness
wiring harness connector J03
2.
If greater than 10 ohms,
Connector J03
socket G1 (Volume 5,
replace engine wiring
Socket G1 and
WP 0800, Figure 48) and
harness. (Volume 4,
Engine Wiring
engine wiring harness
WP 0510) Restore machine to
Harness Connector
connector P05 socket 3
original condition. Clear and
P05 Socket 3.
(Volume 5, WP 0800, Figure
refresh DTCs. (Volume 3,
57). Note reading.
WP 0362)
Measure resistance (Volume
1.
If less than 10 ohms, replace
21.
Open Circuit
fuel rail pressure sensor
Between Engine
3, WP 0369) between engine
Wiring Harness
wiring harness connector J03
(Volume 3, WP 0429) Restore
Connector J03
socket G2 (Volume 5,
machine to original condition.
Socket G2 and
Clear and refresh DTCs.
WP 0800, Figure 48) and
Engine Wiring
engine wiring harness
(Volume 3, WP 0362)
Harness Connector
connector P05 socket 2
2.
If greater than 10 ohms,
P05 Socket 2.
(Volume 5, WP 0800, Figure
replace engine wiring
57). Note reading.
harness. (Volume 4,
WP 0510) Restore machine to
original condition. Clear and
refresh DTCs. (Volume 3,
WP 0362)
1.
Verify engine wiring harness
22.
Check For Fuel Rail
connector P05 is disconnected
Pressure DTC
from fuel rail pressure sensor.
157.03.
(Volume 5, WP 0800, Figure
57)
2.
Turn key switch to ON position,
but DO NOT START ENGINE
(TM 5-3805-294-10). (Volume
5, WP 0794)
3.
Read DTCs. Note all active
DTCs. (Volume 3, WP 0362)
0130-10