TM 5-2420-230-24-1
(4)
Install control cylinder (3) by threading into clevis (6) until flush with back of bracket (8).
(5)
Install nut (7) on control cylinder (3), securing it to bracket (8).
Adhesives, solvents, and sealing compounds burn easily and give off vapors that are harmful to the skin
and clothing. To avoid injury or death, keep away from open fire when using these materials, and use
only in well-ventilated areas. If adhesives, solvents, or sealing compounds contact the skin or clothing,
wash immediately with soap and water, and rinse thoroughly. Failure to comply may result in injury or
death to personnel.
(6) Apply sealing compound, Loctite 567, to fittings (2).
(7) Install two fittings (2) on cylinder (3).
(8) Install two air lines (1) on fittings (2).
c. Follow-On Maintenance.
(1) Start engine and ensure that vehicle properly switches between 2WD and 4WD modes (TM 5-2420-230-10).
(2) Check for air leaks.
(3) Shut OFF engine (TM 5-2420-230-10).
(4) Install center belly plate (TM 5-2420-230-10).
END OF TASK
4-18. TRANSMISSION HIGH/LOW CONTROL CYLINDER REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
References
Test Equipment
None
None
Equipment Conditions
Tools and Special Tools
Tool kit, general mechanics, Item 38, Appendix B
TM or Para
Condition Description
Air system drained.
Materials/Parts
Center belly plate removed.
Compound sealing Loctite 567, Item 22, Appendix C
Pin, cotter, Item 173.1, Appendix D
Drawings Required
TM 5-2420-230-24P Figure 91
Tags, identification, Item 63, Appendix C
TM 5-2420-230-24P Figure 92
Ties, cable, Item 68, Appendix C
TM 5-2420-230-24P Figure 121
Washer, lock, Item 273, Appendix D (2)
Estimated Time to Complete Task
Personnel Required
Refer to MAC in Appendix B
MOS 62B, Construction Equipment Repairer
Change 1