TM 5-2420-230-24-1
4-16. TRANSMISSION MOUNT REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
References
None
None.
Tools and Special Tools
Equipment Conditions
Pan, drain, Item 29, Appendix B
TM or Para
Condition Description
Tool kit, common no. 2, Item 36, Appendix B
Transmission 2/4WD control
Tool kit, general mechanics, Item 38, Appendix B
cylinder removed (left side
only).
Center belly plate removed.
Materials/Parts
Cap and plug set, Item 4, Appendix C
Firewall removed.
Dunnage, suitable
Nut, self-locking, Item 106, Appendix D (2)
Drawings Required
Nut, self-locking, Item 112, Appendix D (8)
TM 5-2420-230-24P Figure 96
Washer, lock, Item 283, Appendix D
TM 5-2420-230-24P Figure 97
Washer, lock, Item 285, Appendix D (2)
Estimated Time to Complete Task
Refer to MAC in Appendix B
Personnel Required
MOS 62B, Construction Equipment Repairer
a. Removal.
Failure to place dunnage between floor jack
and transmission could result in damage to
the vehicle.
NOTE
Left and right side transmission mounts are
removed in the similar manner. Procedure
shown for one mount only.
(1)
Place dunnage between floor jack and
transmission and support transmission.
NOTE
Step (2) is only applicable if the right side
transmission mount is being removed.
(2)
Remove two bolts (1) and lockwashers (2) from transmission mount bracket (3) and transmission. Discard
4-49
Change 1