TM 5-2420-230-24-1
4-15. ENGINE MOUNT REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
References
None
None
Tools and Special Tools
Equipment Conditions
Tool kit, common no. 2, Item 36, Appendix B
TM or Para
Condition Description
Tool kit, general mechanics, Item 38, Appendix B
Nose cone removed.
Materials/Parts
Nut, self-locking, Item 112, Appendix D (4)
Drawings Required
Dunnage, suitable
TM 5-2420-230-24P Figure 23
Personnel Required
Estimated Time to Complete Task
MOS 62B, Construction Equipment Repairer
Refer to MAC in Appendix B
a. Removal.
(1)
Remove bolt (1) and washer (2).
Not placing dunnage between floor jack and
oil pan could result in damage to the vehicle.
(2)
Place dunnage between floor jack and oil
pan and raise engine enough to remove
engine mount (3).
(3)
Remove four bolts (4), self-locking nuts (5),
eight washers (6), and engine mount (3).
Discard self-locking nuts.
b. Installation.
(1)
Install engine mount (3) with four bolts (4),
new self-locking nuts (5), and eight
washers (6). Tighten bolts to 40 lbf/ft
(54 Nm).
(2)
Lower engine on engine mount (3).
(3)
Install bolt (1) and washer (2). Tighten bolts
to 139 lbf/ft (189 Nm).
c. Follow-On Maintenance.
Replace nose cone (Para 13-18).
END OF TASK
Change 1