TM 5-2420-230-24-1
Spicer Speciality Axle Division - Technical Publications
SECTION 20
ASSEMBLY OF SWIVEL JAW AND AXLE STUB
Using service tool no. E550, knock U.J. shaft bush (99) into position in swivel stub (98), ie. flush to 1/16"
20.1
inside shoulder as shown in fig. no. 23 also that double cross-over grooves in bush will be at bottom
when stub and swivel jaw are fitted together. See fig. no. 24.
20.2
Using service tool no. E443 or similar, fit twin lip oil seal (100) 6.3mm down stub bore (98) as shown in
fig no. 31.
TP393
Swivel stub (98)
●
6.3mm
Dirt excluder (101)
●
●
Swivel stub
oil seal (100)
●
Apply auto lubricator
grease 000EP to seal
and bush
U. J. shaft bush (89)
Fig No. 23.
20.3
Fit swivel stub dirt excluder (101) to abut oil seal (100) using tool no. E568.
20.4
Apply a small amount of auto lubricator grease 000EP between oil seal lips (100), also into grooves in
bush (99).
Note :-
This is to ensure that bush and oil seal are lubricated on initial running of axle.
20.5
Using service tool no. E545 knock swivel jaw bearing cup (145) into position in swivel jaw bearing
sleeve (146).
TP734
Correct position
Incorrect position
ie. double cross-over grooves
ie. single cross-over groove
at bottom
at bottom
Fig No. 24.
Manual No. 1785 Issue A
Page No.B21
Spicer Speciality Axle Division
J-51
