TM 5-2420-230-24-1
Spicer Speciality Axle Division - Technical Publications
SECTION 8
BRAKE BRACKET AND CAM SHAFT RE-ASSEMBLY
8.1
Refit brake cam lubricators (34 & 45) with protective caps (35 & 46), if fitted, also lubricator
extension (33) into their positions in brake bracket (29) and cam bracket (44).
8.2
With service tool no. E316 or other suitable bumper tool, refit brake cam bushes (31 & 43) into brake
bracket (29) and brake cam bracket (44) respectively.
NOTE :- Take care to line up lubrication holes in bushes and bracket bosses.
8.3
Using service tool no E414, refit cam oil seals (32 & 42) open side outwards, to abut brake cam
bushes (31 & 43).
8.4
Refit cam bracket (44) onto cam bracket studs (53), and secure in position with nuts and
washers (47 & 48). Tighten nuts to 72 - 80lbs.ft. (98 - 108Nm.).
8.5
Fit brake bracket (29) into position on axle stub (55) and secure with brake bracket bolts and
nuts (62 & 54). Tighten to 95 - 115lbs.ft. (128 - 156 Nm).
8.6
Refit brake anchor pins (25) and washers (26).
8.7
Place cam head washer (27) and cam 'O' ring (28) in position on brake camshaft (23).
8.8
Smear brake cam bushes (31 & 43), 'O' ring (28) and oil seals (32 & 42) with Shell 'Retinax LX' or
equivalent grease, ensuring all indentations are full.
8.9
Feed camshaft assembly into position taking care not to damage seals.
Page No.D7
Manual No. 1785 Issue A
Spicer Speciality Axle Division
J-99