TM 5-2420-230-24-1
19.
Place a new seal ring and tetra seal on the
cylinder head.
NOTE:
A light coat of grease on the seal ring and tetra
seal will hold them in place during mounting
(Figure 141).
Figure 141
20.
Attach the cylinder head to the housing us-
ing the four (4) remaining bolts. Torque to
manufacturer's specifications (Figure 142).
Specifications on page 104 of this manual.
Figure 142
21.
Install the relief plungers in the cylinder head
and bearing cap. Screw in the relief plungers
until they are 1/8" below flush with the end
caps (Figure 143).
Figure 143
K-96