TM 5-2420-230-24-1
11.
To install the piston, carefully work the piston
ring past the sector shaft opening in the
cylinder bore. While maintaining pressure on
the end of the piston, press the piston seal in-
to the ring groove. As the piston ring is com-
pressed into the ring groove, the piston will
slide further into the bore until the piston
ring has passed the sector shaft opening
(Figure 132).
Figure 132
Figure 133
12. Install a new tetra seal on the bearing cap
assembly and attach the bearing cap to the
housing (Figure 134).
NOTE:
A small amount of grease on the tetra seal will
help hold it in place.
Figure 134
K-93