TM 5-2420-230-24-2
Injection Pump - Installation (0-88)
Section 0 - Engine Disassembly and Assembly - Group 00
Page 0-82
B Series Shop Manual
Secure the pump by finger tightening the three mounting
nuts. The pump must be free to move in the slots.
22 mm
Install the drive gear mounting nut and lock washer on the
pump drive shaft.
Torque Value: 15 Nm
[11 ft-lb]
NOTE: This is not the final torque value. The drive shaft
nut will be torqued to the final specification after the
pump is unlocked.
8 mm Allen or 10 mm Hex
Loosen the Bosch pump lockscrew and position the spe-
cial washer behind the lockscrew head.
Tighten the lockscrew in the unlocked position.
Torque Value: 13 Nm
[10 ft-lb]
22 mm
Tighten the drive gear mounting nut.
Torque Value: 65 Nm
[48 ft-lb]
L-171