TM 5-2420-230-24-2
Section 5 - Fuel System - Group 05
Injection Pump Repairs (5-21)
B Series Shop Manual
Page 5-51
19 mm
Install the fuel inlet banjo connector and new sealing
washers in the reverse order of removal.
Fuel Shut Off Solenoid Replacement, Bosch
P7100 (5-32)
10 mm
Remove and replace the shut off solenoid with the part
number facing outward as illustrated.
Torque Value: 9 Nm
[7 ft-lb]
Fuel Shut Off Solenoid Adjustment, Bosch
P7100 (5-33)
NOTE: The fuel pump solenoid must be adjusted on the
vehicle to access the voltage supply.
Connect the solenoid wiring harness to the vehicle wiring
harness.
Turn the key to the ``ON'' position. This will energize the
red (hold) wire and black (common) wire.
This is the low current hold-in coil and must be energized
continuously during this adjustment.
NOTE: Do not turn the key to the ``START'' position at this
time. This will energize the white (pull-in) wire.
L-349
