TM 5-2420-232-10
SUPPORTING INFORMATION
-
AAL TROUBLESHOOTING PROCEDURES
0054
SANDBAGGER TROUBLESHOOTING PROCEDURES
0054
Not All Bags Fall Out While Unloading
00054
Step 1. Check if use is on uneven surface.
Make sure the sandbagger is being operated on a level surface.
Step 2. Check if bucket is straight up.
Bucket must be straight up for proper operation.
Step 3. Check if bags are evenly placed in sandbagger.
Make sure all bags have the ties evenly placed to back of bag holders so bags sit evenly when unloading.
Step 4. If bags still fail to fall out, notify Field Maintenance.
Step 5. Single bag falls out.
Notify Field Maintenance.
Bags Are Too Full
00054
Check if pile is being overdriven.
Drive into the sand pile (or other material being bagged) only as far as necessary for the sandbagger attachment to
reach the Full Fill Guide.
Hydraulic Cylinder Neither Extends Nor Retracts
00054
Step 1. Check if hydraulic oil level too low.
Fill hydraulic tank to proper level (WP 0017).
Step 2. Check if hoses or fittings are loose or disconnected.
If found, notify Field Maintenance.
Step 3. Check if hoses are crimped or crushed.
If found, notify Field Maintenance.
Step 4. If hydraulic cylinder still doesn t extend or retract, notify Field Maintenance.
Hydraulic System Overheats
00054
Step 1. Check if hydraulic oil level is too low.
Fill hydraulic tank to proper level (WP 0017).
Step 2. If hydraulic system still overheats, notify Field Maintenance.
Hydraulic Cylinder Seals Leak
00054
Notify Field Maintenance.
SNOW PLOW TROUBLESHOOTING PROCEDURES
0054
Snow Plow Pivots In Wrong Direction
00054
Step 1. Check if hoses are installed correctly.
Switch hose connection.
Step 2. If snow plow still pivots in the wrong direction, notify Field Maintenance.