TM 5-3805-280-24-2
Crankshaft, Main Bearings and Flywheel
INSTALL FLYWHEEL
15
27
CAUTION: Flywheel is heavy. Plan a proper
handling procedure to avoid injuries.
IMPORTANT: Flywheel MUST BE clean and free of
any oil, grease or debris.
1. Install two guide studs (A) in crankshaft cap screw
threaded holes. Place flywheel on studs and slide into
position against crankshaft.
IMPORTANT: ALWAYS install new flywheel cap
A--Guide Studs
screws when flywheel has been
removed.
2. Apply LOCTITE 242 Thread Lock and Sealer to cap
screws and start cap screws in crankshaft. Do not
tighten until guide studs are removed and all cap
screws are started. Tighten cap screws to
specifications.
Flywheel Mounting Cap Screws--Specification
Torque ......................................................................... 138 Nm (102 lb-ft)
LOCTITE is a registered trademark of Loctite Corp.
RG,15,DT7449 1914NOV971/1
13-205