TM 5-3805-280-24-2
Crankshaft, Main Bearings and Flywheel
15
IMPORTANT: Handle the rear oil seal and sleeve
33
assembly carefully. If wear sleeve
surface is scratched, gouged or any
sealant (liquid) is present, order a new
seal assembly.
4. Carefully start oil seal (B) and wear sleeve over pilot
and crankshaft flange with open side of seal toward
engine.
5. Attach JT30042 Driver (A) and thrust washer to the
guide plate with cap screw. Tighten the cap screw until
driver bottoms on pilot.
6. Remove seal driver and pilot plate. Check that seal
A--Driver
and wear sleeve assembly is properly positioned on
B--Seal
crankshaft flange and installed square in flywheel
housing bore.
Continued on next page
RG,15,DT7446 1914NOV973/4
13-211