TM 5-3805-281-24-2
Removal and Installation
IMPORTANT: Use JDE90 Serrated Wrench (B) to keep
delivery valve fittings stationary while
tightening fuel line nuts. If a delivery
valve and barrel housing rotates while
tightening a fuel line nut, injection
pump fuel delivery will be altered, and
pump will have to be recalibrated on a
test stand.
18. Remove protective caps and plugs, that were installed
during disassembly, from injection lines, nozzles and
delivery valves. Install and connect injection line
assembly at each respective injection nozzle and
delivery valve.
A--Fuel Injection Line Nut
B--JDE90 Serrated Wrench
C--JDF22 Crowsfoot Wrench
19. Tighten fuel injection line nuts (A).
04
0400
Fuel Injection Nozzle Line Nut--Specification
33
Torque ............................................................................. 27 Nm (20 lb-ft)
20. Tighten line nuts at delivery valves using JDF22
Crowsfoot Wrench (C) or a 3/4 in. line wrench along
with JDE90 Serrated Wrench.
Fuel Injection Nozzle Line Nut--Specification
Torque ............................................................................. 27 Nm (20 lb-ft)
21. Bleed fuel system. (See procedure in this group.)
CED,OUOE024,211
1918MAY987/7
11-33
