TM 5-3805-281-24-2
Cylinder Head and Valves
MEASURE CYLINDER LINER STANDOUT
(HEIGHT ABOVE BLOCK)
1. Bolt down liners using cap screws and flat washers in
the seven locations as shown. Flat washers should be
at least 3.18 mm (1/8 in.) thick. Tighten cap screws to
68 Nm (50 lb-ft) to achieve an accurate standout
reading.
NOTE: Liners having obvious defects must be replaced.
2. Using JDG451 Gauge (A) along with D17526CI
(English) or D17527CI (Metric scale) Dial Indicator (B)
or KJD10123 Gauge to measure the height of bolted
down liners that are not obviously defective before
removal from block.
Bolting Down Cylinder Liners
NOTE: Variations in measurement readings may occur
within one cylinder and/or between adjacent
cylinders.
3. Measure each liner in four places, approximately at 1,
5, 7 and 11 O'clock positions as viewed from the rear
of the engine (flywheel end). Record all measurements
by cylinder number.
4. Remove any liner that does not meet standout
specification at any location and install liner shims or
replace piston/liner sets as necessary. (See INSTALL
LINER SHIMS--IF REQUIRED, in Group 10.)
Checking Cylinder Liner Height Above Block
Liner--Specification
Height .................................................... 0.051--0.127 mm (0.002--0.005
in.) above block
RG,RG34710,1100
1923OCT971/1