TM 5-3805-281-24-2
Crankshaft, Main Bearings, and Flywheel
INSTALL CRANKSHAFT REAR OIL SEAL
HOUSING
These instructions are for when oil seal housing and oil
pan have been removed from cylinder block.
1. Make sure the O.D. of crankshaft flange (A) and I.D. of
seal housing (B) are free from nicks or burrs. Restore
damaged surfaces with a fine file or emery cloth. Clean
with compressed air.
2. Install oil seal housing (C) on cylinder block using a
Installing Crankshaft Rear Oil Seal Housing
new gasket. Install all six cap screws with washers,
using LOCTITE 242 on threads. Tighten screws finger
tight.
LOCTITE is a trademark of Loctite Corp.
Continued on next page
RG,RG34710,1182
1923OCT971/2