TM 5-3805-281-24-2
Crankshaft, Main Bearings, and Flywheel
4. Position JDG478 Driver (A) so that hole in the cross
plate goes over threaded stud of pilot. Install washer
and nut on stud.
5. Tighten nut to draw JDG478 Driver in until crossbar
bottoms on JDG477 (58) Pilot. When the tool bottoms,
seal and wear ring assembly (B) will be correctly
positioned.
6. Remove JDG476 (85) Tool Set from engine.
Rear Oil Seal and Wear Sleeve Installed
RG,RG34710,1185
1923OCT972/2
11-246