TM 5-3805-294-10
0019
INSTALLING CRUSH-ALL - Continued
WARNING
Keep hands away from pin and alignment holes while thumb is being moved. Only use prybar
to push pin. Failure to comply may result in injury or death to personnel.
NOTE
Thumb may need to be repositioned multiple times with slight movements of the cylinder until
proper alignment of thumb to arm is achieved in order for pin to slide completely through.
5.
Using prybar to push pin (Figure 1, Item 3), install pin in thumb lock position (Figure 1, Item 5).
6.
Install retaining clip (Figure 1, Item 2) on pin (Figure 1, Item 3).
NOTE
There are two auxiliary circuit shutoff valves. There is one located on both sides of the arm.
Left side shown.
7.
Close two auxiliary circuit shut off valves (Figure 1, Item 6).
8.
Move quick latch switch (Figure 2, Item 7) to unlatch position.
7
HYEX03393
Figure 2.
Move Quick Latch Switch to Unlatch Position.
9.
Fully extend bucket cylinder (Figure 3, Item 8) to ensure quick latch wedges (Figure 3, Item 9) are fully retracted.
