TM 5-3805-294-10
0019
INSTALLING CRUSH-ALL - Continued
34.
Remove cap (Figure 8, Item 27) from connector (Figure 8, Item 28).
35.
Attach connector (Figure 8, Item 29) to connector (Figure 8, Item 28).
END OF TASK
OPERATION
1.
Start machine. (WP 0007)
2.
Select the Pulverizer 1 on the monitor. (WP 0018)
3.
Turn on the Auxiliary Control Switch. (WP 0004)
4.
Adjust discharge size as needed. (WP 0092)
WARNING
Ensure operator protection guard is installed prior to operation. Failure to comply may
result in injury or death to personnel.
Crush-All can throw objects at any time during operation. Ensure personnel maintain
distance of 150 ft (45.72 m). Failure to comply may result in injury or death to personnel.
Do not reach into machine to remove debris. Failure to comply may result in injury or
death to personnel.
Do not operate Crush-All with guards, panels, or covers removed. Failure to comply may
result in injury or death to personnel.
CAUTION
Do not overload Crush-All, strike objects or ground, or use sides of Crush-All to move material.
Failure to comply may result in damage to equipment.
NOTE
When crushing concrete, asphalt, brick, block, or softer stone, the maximum feed size is
18 in. x 18 in. (45.72 cm x 45.72 cm).
When crushing slag, limestone, or other materials with dirt, the maximum feed size is 15
in. x 5 in. (38.1 cm x 12.7 cm).
To reduce dust output, wet down material prior to crushing.
5.
Place engine at full speed while crushing. (WP 0004)
6.
Lift Crush-All (Figure 9, Item 11) approximately 6 ft (182.8 cm) off ground.
0019-6