TM 5-3805-294-23-1
0022
Table 1. DTC 100.04 - Engine Oil Pressure Signal Out Of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
1.
Disconnect engine wiring
15.
Short Circuit
harness connector J01.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
46)
Socket C3 and All
Other Sockets on
Engine Wiring
Harness
Connectors J03 and
J01.
2.
Verify engine wiring harness
connector P04 is disconnected
from engine oil pressure
sensor. (Volume 5, WP 0800,
Figure 56)
3.
Measure resistance (Volume
1.
If any measurement was less
than 100 kohms, replace
3, WP 0369) between engine
engine wiring harness.
wiring harness connector J03
socket C3 and all other sockets
(Volume 4, WP 0510) Restore
on engine wiring harness
machine to original condition
connectors J03 (Volume 5,
and perform Harness
Diagnostic Mode Test.
WP 0800, Figure 48) and
(Volume 3, WP 0345)
J01. (Volume 5, WP 0800,
Figure 46)
2.
If all measurements were
Note readings.
greater than 100 kohms,
proceed to Malfunction 16.
1.
Disconnect engine wiring
16.
Short Circuit
harness connector J02.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
47)
Socket C3 and All
Other Sockets on
Engine Interface
Wiring Harness
Connector J02.
0022-9