TM 5-3805-294-23-1
0022
Table 1. DTC 100.04 - Engine Oil Pressure Signal Out Of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
6.
Select Engine Control Unit
(ECU) Only. (Volume 3,
WP 0363)
7.
Under Connected Data Points,
select ECU - (shown with
engine serial number).
(Volume 3, WP 0363)
8.
Under ECU - (shown with
engine serial number), select
ECU - Data List - All. (Volume
3, WP 0363)
9.
Under ECU - Data List - All,
select Engine Oil Pressure
Input Voltage. (Volume 3,
WP 0363)
10.
Monitor the Engine Oil
Pressure Input Voltage. Note
reading.
11.
When finished monitoring,
select Readings and select
Disconnect From Model(s).
(Volume 3, WP 0363)
12.
Select Yes to terminate your
readings connection. (Volume
3, WP 0363)
13.
Turn the key switch to the OFF
1.
If voltage is 4.8 volts or greater,
position (TM 5-3805-294-10).
proceed to Malfunction 6.
(Volume 5, WP 0794)
2.
If voltage is less than 4.8 volts,
proceed to Malfunction 10.
1.
Remove jumper wire from
6.
DTC 100.04 is
engine wiring harness
Displayed Active.
connector P04. (Volume 5,
WP 0800, Figure 56)
2.
Connect engine wiring
harness connector P04 to
engine oil pressure sensor.
3.
Turn the key switch to the ON
position, but DO NOT START
ENGINE (TM 5-3805-294-10).
(Volume 5, WP 0794)
0022-4