TM 5-3805-294-23-1
0022
Table 1. DTC 100.04 - Engine Oil Pressure Signal Out Of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
4.
Refresh DTCs. Note if DTC
100.04 is still active. (Volume
3, WP 0362)
5.
Turn the key switch to the OFF
1.
If DTC 100.04 is still active,
position (TM 5-3805-294-10).
replace engine oil pressure
(Volume 5, WP 0794)
sensor. (Volume 3, WP 0417)
Restore machine to original
condition and perform Harness
Diagnostic Mode Test.
(Volume 3, WP 0345)
2.
If DTC 100.04 is not active,
proceed to Malfunction 7.
1.
Turn the key switch to the ON
7.
Intermittent
position, but DO NOT START
Connection.
ENGINE (TM 5-3805-294-10).
(Volume 5, WP 0794)
2.
Select Readings and select
Connect to Model(s). (Volume
3, WP 0363)
3.
Select Dearborn Protocol
Adapter (DPA 4+) USB for the
Readings Adapter, and select
OK. (Volume 3, WP 0363)
4.
Select Engine Control Unit
(ECU) Only. (Volume 3,
WP 0363)
5.
Under Connected Data Points,
select ECU - (shown with
engine serial number).
(Volume 3, WP 0363)
6.
Under ECU - (shown with
engine serial number), select
ECU - Data List - All. (Volume
3, WP 0363)
7.
Under ECU - Data List - All,
select Engine Oil Pressure
Input Voltage. (Volume 3,
WP 0363)
8.
Monitor the Engine Oil
Pressure Input Voltage. Note
reading.
0022-5