TM 5-3805-294-23-1
0048
Table 1. DTC 611.04 - Injector Shorted to Voltage Source - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Measure resistance between
1.
If less than 1 kohms, replace
each electronic fuel injector
electronic fuel injector(s)
reading less than 1 kohms.
stud (Volume 5, WP 0800,
Figure 145) and a known good
(Volume 3, WP 0408) Restore
ground. Note reading.
machine to original condition
and perform Harness
Diagnostic Mode Test.
(Volume 3, WP 0345)
2.
If greater than 1 kohms,
replace electronic fuel injector
wiring harness. (Volume 3,
WP 0409) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
1.
Disconnect engine wiring
7.
Engine Wiring
harness connector J01.
Harness Connector
J01 Has Damage or
(Volume 5, WP 0800, Figure
Loose Sockets.
46)
2.
Visually inspect engine wiring
1.
If damaged or has loose
harness connector J01 for
sockets, replace engine wiring
damage and loose sockets.
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 8.
Visually inspect ECU
1.
If damaged or has loose pins,
8.
ECU Connector J01
connector J01 for damage and
replace ECU. (Volume 4,
Has Damage or
loose pins. (Volume 5,
Loose Pins.
WP 0508) Restore machine to
WP 0800, Figure 146)
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose pins, proceed to
Malfunction 9.
0048-5