TM 5-3805-294-23-1
0116
Table 1. Engine Does Not Develop Full Power - Continued.
Test or Inspection
Corrective Action
Malfunction
7.
Under ECU - Data List - All,
select Engine Load at Current
Speed. (Volume 3, WP 0363)
8.
Operate engine at speed and
load where low power
occurred. (TM 5-3805-294-10)
(Volume 5, WP 0794)
9.
Monitor Engine Load at
Current Speed data point in
Service ADVISOR. Note
reading.
10.
When finished monitoring,
select Readings and select
Disconnect From Model(s).
(Volume 3, WP 0363)
11.
Select Yes to terminate your
readings connection. (Volume
3, WP 0363)
12.
Shut down engine and turn key
1.
If Engine Load at Current
switch to OFF position. (TM
Speed data point is 95% or
5-3805-294-10) (Volume 5,
higher proceed to Malfunction
31.
WP 0794)
2.
If Engine Load at Current
Speed data point is less than
95%, it is possible that another
fault exists or that another
troubleshooting procedure
applies. If this was the first time
through this procedure, restart
procedure at Malfunction 1.
1.
Disconnect engine wiring
31.
Engine Wiring
harness connector P05 from
Harness Connector
fuel rail pressure sensor.
P05 Has Damage or
Loose Sockets.
(Volume 5, WP 0800, Figure
57)
0116-14