TM 5-3805-294-23-1
0137
Table 1. DTC 13311.04 - Fuel Level Sensor Open Circuit - Continued.
Test or Inspection
Corrective Action
Malfunction
3.
Visually inspect connector X3
1.
If damaged or has loose pins/
for damage and loose pins/
sockets, replace cab wiring
sockets.
harness for socket side of
connector (Volume 4,
WP 0504) or replace machine
wiring harness for pin side of
connector. (Volume 4,
WP 0516) Restore machine to
original condition. Clear and
refresh DTCs. (Volume 3,
WP 0362)
2.
If not damaged and does not
have loose pins/sockets,
proceed to Malfunction 8.
Measure resistance (Volume
1.
If continuity is present, replace
8.
Open Circuit
machine wiring harness.
Between Connector
3, WP 0369) between
X21 Socket 2 and
connector X21 socket 2
(Volume 4, WP 0516) Restore
Connector X3
machine to original condition.
(Volume 5, WP 0800, Figure
Socket 22.
Clear and refresh DTCs.
88) and connector X3 socket
(Volume 3, WP 0362)
22. (Volume 5, WP 0800,
Figure 84) Note reading.
2.
If continuity is not present,
proceed to Malfunction 9.
1.
Remove cab rear tray.
9.
Connector X24 Has
Damage or Loose
(Volume 4, WP 0566)
Pins/Sockets.
2.
Disconnect connector X24.
(Volume 5, WP 0800, Figure
91)
3.
Visually inspect connector X24
1.
If damaged or has loose pins/
for damage and loose pins/
sockets, replace monitor
sockets.
controller wiring harness for
pin side of connector (Volume
4, WP 0519) or replace cab
wiring harness for socket side
of connector. (Volume 4,
WP 0504) Restore machine to
original condition. Clear and
refresh DTCs. (Volume 3,
WP 0362)
If not damaged and does not
2.
have loose pins/sockets,
proceed to Malfunction 10.
0137-4