TM 5-3805-294-23-1
0136
Table 1. DTC 13311.03 - Fuel Level Sensor Short Circuit - Continued.
Test or Inspection
Corrective Action
Malfunction
3.
Visually inspect connector X3
1.
If damaged or has loose pins/
for damage and loose pins/
sockets, replace cab wiring
sockets.
harness for socket side of
connector (Volume 4,
WP 0504) or replace machine
wiring harness for pin side of
connector. (Volume 4,
WP 0516) Restore machine to
original condition. Clear and
refresh DTCs. (Volume 3,
WP 0362)
2.
If not damaged and does not
have loose pins/sockets,
proceed to Malfunction 8.
Measure resistance (Volume
1.
If continuity is not present,
8.
Shorted Circuit
proceed to Malfunction 9.
Between Connector
3, WP 0369) between
X3 Pin 22 and
connector X3 pin 22 (Volume
2.
If continuity is present, replace
Ground.
5, WP 0800, Figure 84) and
machine wiring harness.
known good ground. Note
(Volume 4, WP 0516) Restore
reading.
machine to original condition.
Clear and refresh DTCs.
(Volume 3, WP 0362)
1.
Remove cab rear tray.
9.
Connector X24 Has
Damage or Loose
(Volume 4, WP 0566)
Pins/Sockets.
2.
Disconnect connector X24.
(Volume 5, WP 0800, Figure
91)
3.
Visually inspect connector X24
1.
If damaged or has loose pins/
for damage and loose pins/
sockets, replace monitor
sockets.
controller wiring harness for
pin side of connector (Volume
4, WP 0519) or replace cab
wiring harness for socket side
of connector. (Volume 4,
WP 0504) Restore machine to
original condition. Clear and
refresh DTCs. (Volume 3,
WP 0362)
If not damaged and does not
2.
have loose pins/sockets,
proceed to Malfunction 10.
0136-4