TM 5-2420-230-24-1
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are
harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in
well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash
immediately with soap and water. Failure to comply may result in injury or death to personnel.
(4)
Apply sealing compound to drain plug threads.
(5)
Refit drain plug in bottom of hydraulic reservoir.
c. Refilling.
Add fresh hydraulic oil to hydraulic reservoir until oil level is above LOW mark.
d. Follow-On Maintenance.
(0.1) Close hood.
(1)
Start engine (TM 5-2420-230-10).
(2)
Operate FEL and backhoe to bleed system (TM 5-2420-230-10).
(3)
Check drain plug for signs of leakage. Tighten as necessary.
(4)
With all hydraulic components retracted, ensure oil level is correct (TM 5-2420-230-10).
(5)
Shut OFF engine (TM 5-2420-230-10).
(6)
Install front, left-hand belly plate (TM 5-2420-230-10).
END OF TASK
10-10. HYDRAULIC OIL FILTER REPLACEMENT.
This Task Covers:
a. Preparation
b. Removal
c. Replacement
d. Follow-On Maintenance
INITIAL SETUP
Test Equipment
References
None
None
Tools and Special Tools
Equipment Conditions
Pan, drain, Item 29, Appendix B
TM or Para
Condition Description
Tool kit, general mechanics, Item 38, Appendix B
Front, left-hand belly plate
removed.
Materials/Parts
Cloth, lint-free, Item 10, Appendix C
Drawings Required
Dexron III, Item 27, Appendix C
TM 5-2420-230-24P Figure 150
Filter element, oil, Item 48.3, Appendix D
Estimated Time to Complete
Refer to MAC in Appendix B
Personnel Required
MOS 62B, Construction Equipment Repairer
Change 1