TM 5-2420-230-24-1
b. Installation.
Ensure pins are lubricated before installing.
Failure to comply could result in damage to
equipment.
NOTE
Ensure all hoses and tubes are reconnected to
positions noted prior to removal.
Install cable ties as necessary.
(1)
Attach suitable lifting device and sling to
stabilizer cylinder (2).
Use care when removing or installing snap and
retaining rings. Snap and retaining rings are
under spring tension and can act as projectiles
when released and could cause severe eye injury.
(2)
Use lifting device to position stabilizer cylinder (2) and install with top pivot pin (6), two circlips (5), bottom pivot
pin (4), and two circlips (3).
(3)
Install fittings if necessary.
(4)
Connect two hydraulic hoses (1) to stabilizer cylinder (2).
c. Follow-On Maintenance.
(1)
Start engine and functionally test cylinders (TM 5-2420-230-10).
(2)
Shut OFF engine (TM 5-2420-230-10).
(3)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
Change 1
10-46