TM 5-2420-230-24-1
b. Installation.
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short may
result. Damage to equipment and injury or
death to personnel may occur.
NOTE
Ensure all wires are reconnected to
positions noted prior to removal.
Install cable ties as necessary.
(1)
Install seal, if previously removed.
(2)
Install ECU (6) and install two bolts (5).
(3)
Install wiring connectors (4) and tighten.
(4)
Install retaining clips (3) with cover
plate (2).
(5)
Secure cover plate (2) with two bolts (1). Tighten bolts.
c. Follow-On Maintenance.
(1)
Start engine (TM 5-2420-230-10).
(2)
Carry out hydraulic calibration procedure (Para 10-26).
(3)
Shut OFF engine (TM 5-2420-230-10).
(4)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
Change 1
12-67