TM 5-2420-230-24-1
b. Installation.
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short may
result. Damage to equipment and injury or
death to personnel may occur.
NOTE
Install cable ties as necessary.
(1)
Place rear wiper motor mount (10) and rear
wiper motor gearbox shaft (12) in position and
secure bushing (9), washer (8), and nut (7) to
rear wiper motor mount (10). Install rear wiper
arm assembly (11) to rear wiper motor
gearbox shaft (12).
(2)
Connect wiring harness (5) to rear wiper
motor (6).
(3)
Operate wiper and switch off to check proper
park position. If wiper is in proper park
position, proceed to Step (5), if not, proceed to
Step (4).
(4)
Relocate wiper arm to desired park position and install rear wiper arm assembly (11) to rear wiper motor gearbox
shaft (12).
(5)
Install two screws (1), two grommets (2), wiper/washer switch (3), and wiper motor cover (4).
(6)
Ensure all bolts are tightened.
c. Follow-On Maintenance.
(1)
Wiper blade replaced (Para 13-22).
(2)
Start engine and functionally test rear wiper motor (TM 5-2420-230-10).
(3)
Shut OFF engine (TM 5-2420-230-10).
(4)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
Change 1
12-62