TM 5-2420-230-24-1
12-31. WASHER BOTTLE ASSEMBLY AND BRACKET REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Vehicle positioned on level
Tools and Special Tools
ground.
Tool kit, general mechanics, Item 38, Appendix B
Parking brake applied.
Engine shut OFF.
Materials/Parts
Electrical master switch OFF.
Tags, identification, Item 63, Appendix C
"Do Not Operate" tag attached
Ties, cable, Item 68, Appendix C
to ignition switch.
Washer, lock, Item X, Appendix D (2)
Hood raised.
Washer, lock, Item 279, Appendix D (2)
Washer, lock,Item 281, Appendix D (3)
Drawings Required
TM 5-2420-230-24P Figure 15
Personnel Required
TM 5-2420-230-24P Figure 67
MOS 62B, Construction Equipment Repairer
References
Estimated Time to Complete Task
None
Refer to MAC in Appendix B
a. Removal.
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short may
result. Damage to equipment and injury or
death to personnel may occur.
NOTE
Tag all hoses and wires and note their
positions before removal.
Remove cable ties as necessary.
Ensure all hoses and wires are disconnected
and cleared before removal.
(1)
Remove two wiring harness plugs (1) from
from two washer pumps (2).
(2)
Remove two washer hoses (3) from two washer pumps (2).
(3)
Remove two bolts (4), lockwashers (5), and washer bottle assembly (6) from washer bottle bracket (7). Discard
(4)
If required, remove washer pumps (2) from washer bottle assembly (6).
Change 1