TM 5-2420-230-24-2
L-35. ENGINE REPAIR (VALVE TAPPETS REPLACEMENT).
This Task Covers:
a. Removal
b. Inspection
c. Installation
d. Follow-On Maintenance
INITIAL SETUP
Test Equipment
References
None
None
Equipment Conditions
Tools and Special Tools
TM or Para
Condition Description
Tool kit, general mechanics, Item 38, Appendix B
Tappet cover removed.
Camshaft removed.
Materials/Parts
Grease, lithium, Item 34, Appendix C
Drawings Required
TM 5-2420-230-24P Figure 6
Personnel Required
MOS 62B, Construction Equipment Repairer
Estimated Time to Complete
Refer to MAC in Appendix B
a. Removal.
Fuel and oil are slippery and can cause falls. To avoid injury, wipe up spilled fuel or oil with rags.
Refer to page L-121 for removal.
b. Inspection.
Refer to page L-297 for inspection.
c. Installation.
Adhesives, solvents, and sealing compounds burn easily and give off vapors that are harmful to the
skin and clothing. To avoid injury or death, keep away from open fire when using these materials, and
use only in well-ventilated areas. If adhesives, solvents, or sealing compounds contact the skin or
clothing, wash immediately with soap and water, and rinse thoroughly. Failure to comply may result in
injury or death to personnel.
Refer to page L-131 for installation.
d. Follow-On Maintenance.
(1)
Install tappet cover (Para L-28).
(2)
Install camshaft (Para L-34).
END OF TASK
Change 1