TM 5-2420-230-24-2
Section 0 - Engine Disassembly and Assembly - Group 00
Suction Tube - Installation (0-82)
B Series Shop Manual
Page 0-67
Apply a mild soap to the rubber outside diameter of the
oil seal.
Use the alignment and installation tool packaged in the
seal kit. Drive the seal into the housing until the driver
bottoms.
NOTE: Alternately, drive the seal at the 12, 3, 6 and 9 o'clock
positions to install the seal square to the crankshaft flange.
Make sure the seal housing is level with both sides of the
cylinder block oil pan rail. Tighten the rear cover
capscrews.
Torque Value: 7 Nm
[80 in-lb]
Remove the seal pilot tool. Trim the gaskets even with the
oil pan mounting surface.
Suction Tube - Installation (0-82)
Position the suction tube and gasket on the cylinder block.
L-156