TM 5-2420-230-24-2
Section 0 - Engine Disassembly and Assembly - Group 00
Injection Pump - Installation (0-88)
B Series Shop Manual
Page 0-71
Injection Pump - Installation (0-88)
Install the injection pump gasket. The Nippondenso EP9
and the Bosch P7100 injection pump use a sealing o-ring
instead of a sealing gasket. Make sure the o-ring is po-
sitioned properly and not damaged. Lubricate with clean
engine oil.
Install the key in the keyway of the Bosch and CAV in-
jection pump shafts. The Nippondenso EP9 and the Bosch
P7100 pumps do not require a key.
Service Tip: To prevent the key from falling out of the
keyway in the shaft, use a small punch to swell one side
of the key. When adequately expanded, it should require
a hammer to lightly tap the key into posiiton in the keyway.
Locate top dead center (TDC) for Cylinder Number 1 by
barring the engine while pushing in on the engine timing
pin until it engages.
L-160
