TM 5-2420-230-24-2
Section 0 - Engine Disassembly and Assembly - Group 00
Injection Pump - Installation (0-88)
B Series Shop Manual
Page 0-73
Attach the pump by finger tightening the mounting nuts.
The pump must be free to move.
22 mm
Install the drive gear mounting nut and spring washer.
The pump can rotate slightly due to gear helix and clear-
ance. This is acceptable providing the pump is free to
move on the flange slots and the crankshaft does not
move.
Torque Value: 15 Nm
[11 ft-lb]
This is not the final torque. The drive shaft nut will be
torqued to the final specification after the pump is
unlocked.
13 mm or 15 mm
Rotate the pump to align the scribe marks and tighten the
mounting nuts. The Nippondenso EP9 and Bosch inline
do not have alignment marks.
Torque Value
Nippondenso EP9
43 Nm [32 ft-lb]
Bosch P7100
43 Nm [32 ft-lb]
Lucas CAV, Stanadyne, Bosch VE
30 Nm [22 ft-lb]
If a new or rebuilt Stanadyne, Bosch or CAV pump without
scribe marks is being installed, take up the gear lash by
rotating the pump against the direction of drive rotation.
Make sure the engine is at TDC.
Tighten the pump retaining nuts.
Torque Value: 24 Nm
[18 ft-lb]
L-162