TM 5-2420-230-24-2
Section 0 - Engine Disassembly and Assembly - Group 00
Drive Belt - Installation (0-123)
B Series Shop Manual
Page 0-113
Drive Belt - Installation (0-123)
3/8 inch Square Drive
Lift the tensioner and install the belt.
Service Tip: If difficulty is experienced installing the drive
belt (the belt seems too short), position the belt over the
grooved pulleys first and then while holding the tensioner
up, slide the belt over the water pump pulley.
Oil Filter - Installation (0-124)
Lubricate the filter seal and tighten the filter according to
the filter manufacturer's instructions.
Be sure to use the correct filter for your engine. Fleetguard
LF3345 is used only for the 4B engine. Fleetguard LF3349
can be used for the 4B and 6B engine.
Rollover Stand - Engine Removal
(0-125)
18 mm
Install the rear lifting bracket.
Torque Value: 77 Nm
[57 ft-lb]
Remove the engine from the rollover stand.
Engine Weight
4B engine (wet) weight: 325-350 Kg [715-770 lb]
6B engine (wet) weight: 410-440 Kg [910-970 lb]
L-202