TM 5-2420-230-24-2
B3.9 and B5.9 Series Engines
Flywheel Housing (016-006)
Section 16 - Mounting Adaptations - Group 16
Page 16-19
Dry Clutch Application
Install rectangular seal, and lubricate with LubriplateTM 105,
or equivalent.
Inspect the rear face of the cylinder block and flywheel
housing mounting surface for cleanliness and raised nicks
or burrs.
Install the flywheel housing over the two ring dowels.
NOTE: Be sure the sealing ring is not damaged during
installation.
Tighten the flywheel housing capscrews in the sequence
shown.
Torque Value: 77 Nm
[57 ft-lb]
Wet Clutch Application
Perform all the steps in the procedure for dry clutch in-
stallation, in addition to the following:
Coat the flywheel housing drain plug with pipe seal-
ant, and install in the hole in the bottom of the
flywheel housing.
Tighten the plug.
Refer to the pipe plug torque values in Section 17
for different plug sizes.
L-1347
