TM 5-2420-230-24-2
Flywheel Housing (016-006)
B3.9 and B5.9 Series Engines
Page 16-20
Section 16 - Mounting Adaptations - Group 16
Install the plastic plug in the tachometer drive access hole.
Install the access plate and new gasket.
Install the capscrews and tighten.
Torque Value: 24 Nm
[18 ft-lb]
WARNING
When using a steam cleaner, wear safety glasses or a
face shield, as well as protective clothing. Hot steam
can cause serious personal injury.
WARNING
When using solvents, acids, or alkaline materials for
cleaning, follow the manufacturer's recommendations
for use. Wear goggles and protective clothing to avoid
personal injury.
Thoroughly clean the flywheel housing and cylinder block
mating surfaces. These surfaces must be clean of oil and
debris.
NOTE: The capscrew holes on the mounting pads are
drilled through. Coat set screws with Loctite 277 and install
into holes.
Set Screw Installation Depth (Flywheel Housing)
mm
in
3.00
MAX
0.118
L-1348